Need some help!

Hey guys!

I'm new customising MOTUC figures.

So, I need some custom tips for the MOTUC toy line.

Ok, I need to remove a loincloth without slit it.

How I can remove it without slit it or damage the figure's torso?!

Any help would be greatly appreciate!

Thanks,
-Peter

i heat mine under a desk lamp for a bit till is very soft and take off the legs and just pull the sucker off.... i do it quite often and have yet to ruin a loin...cloth that it...

A hair dryer can be used?

Yes you can use a hair dryer. Just be careful not to use the highest setting. Make sure to keep your hair dryer at least 4 inches away from the area you are heating, and use a circular motion in that spot for at least 45 seconds. You will be good to go! :hmgrin:

So, the MOTUC figures do not come apart at the waist?

So, I have to heat the figure with a hair dryer, pull off his legs at the thighs, then heat the loin cloth and pull it off. Then heat the new loincloth and slide it on the figure?

LMK.

-Peter

I have seen loin cloths tear, so be careful when pulling it off. Also, a lot of people boil water and place the figure in it for 10 to 15 seconds, it makes the parts really soft.

Hey guys!

Thanks for the tips! All of them worked like a charm!