Need some help!

[peterh01]

Hey guys!

I'm new customising MOTUC figures.

So, I need some custom tips for the MOTUC toy line.

Ok, I need to remove a loincloth without slit it.

How I can remove it without slit it or damage the figure's torso?!

Any help would be greatly appreciate!

Thanks,
-Peter

[H.A.L.9000]

i heat mine under a desk lamp for a bit till is very soft and take off the legs and just pull the sucker off.... i do it quite often and have yet to ruin a loin...cloth that it...

[peterh01]

A hair dryer can be used?

[joseephus]

Yes you can use a hair dryer. Just be careful not to use the highest setting. Make sure to keep your hair dryer at least 4 inches away from the area you are heating, and use a circular motion in that spot for at least 45 seconds. You will be good to go!

[peterh01]

So, the MOTUC figures do not come apart at the waist?

So, I have to heat the figure with a hair dryer, pull off his legs at the thighs, then heat the loin cloth and pull it off. Then heat the new loincloth and slide it on the figure?

LMK.

-Peter

[masterenglish]

I have seen loin cloths tear, so be careful when pulling it off. Also, a lot of people boil water and place the figure in it for 10 to 15 seconds, it makes the parts really soft.