My Beast Man Has Inverted Legs!

[jscott991]

I finally acquired a Beast Man for a reasonable price and it turns out his legs are backwards. Or it might just be his feet. It's hard to tell.

Is there any way to easily fix this?

I'm guessing no based on a preliminary inspection of the figure.

beast.jpgbeast2.jpg

[PlatinumFist]

It looks like you just need to switch the legs. Use a hair dryer to soften the plastic, remove the legs and pop them in the right position.

[jscott991]

It looks like you just need to switch the legs. Use a hair dryer to soften the plastic, remove the legs and pop them in the right position.

Wow, it's that easy?

If so, that's a huge relief.

[nanoFatato]

Yes but be careful to not stress too much the plastic, even if it's warmed by the hair dryer, here's a photo posted by samueljd that should helps you
http://www.he-man.org/forums/boards/...=1#post2565319

[shadowfall1976]

Heat up a bowl of water to boiling in the microwave, it's much safer than the hair dryer, and it works faster. No chance you might accidentally melt anything, and the water will get into the joints loosening them easier, unlike the hair dryer. Also, less chance of breakable too, because the water heats everything consistently.

[mikethedrummer]

Thanks for providing suggestions gang!