Results 1 to 3 of 3

Thread: Quick help with leg joints

  1. #1
    Heroic Warrior ToyCulture's Avatar
    Join Date
    Jun 2018
    Posts
    79

    Quick help with leg joints

    I´m trying to build a custom figure but cant get the knee peg through both holes. No chance. Any advice?

    custom1.jpg

    custom2.jpg




  2. #2
    Heroic Warrior H.A.L.9000's Avatar
    Join Date
    Mar 2010
    Location
    Ba'hee Priss Dimmie Forever!!
    Posts
    1,879
    what i do is.. i put the the leg set up under a hot lamp..or use a hair dryer... and heat er up for a bit till the legs are slightly bendy...

    the but the leg on a flat surface and use the back of a screw driver to punch down on the opposite side of where the button is not engaging. with force..it should pop in...
    "The worst horror movie i saw last year...was the best movie i saw last year"- Stephan King

  3. #3
    Heroic Warrior ToyCulture's Avatar
    Join Date
    Jun 2018
    Posts
    79
    All right, I used close to boiling hot water for a 1.5 minutes, then pushed the peg through from the outside with a watchmakers hammer. Worked.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •